CONSTRUCTION OF AN AUTOMATED BOREHOLE REGULATOR

In Nigeria, a borehole is one of the best means of obtaining clean water in field condition. However, field operations in remote areas or in difficult conditions often require flexibility and imagination in avoiding and solving technical problems. The automated borehole regulator serves as a means to control the pumping of water between predefined upper and lower limits.This system mainly works on a principle that “water conducts electricity”. 5 wires are dipped into the tank with a certain gap between each wire will indicate the different water levels. Based on the outputs of these wires, microcontroller displays water level using LEDs as well as controls the flow of water by controlling the motor of the pump. In the 1st phase, the program is burnt into the microcontroller and the 5 copper wires are used to indicate water level and a motor controls the flow of water. An increase in the water level is determined by the wires and the signal is sent to the microprocessor and afterwards displayed on the LCD screen.The overall system testing of integrated design of voltage measurement device. The testing and integration is done to ensure that the design is functioning properly as expected thereby enabling the intended user(s) for which the project was targeted for, appreciate its implementation and equally approaches used in the design and integration of various modules of the project.